After the truck reaches the destination, place the suction tube to the ordered
position.
Locate the four ways valve at the position of “drain”, start the engine, step
the clutch, gear to the PTO and then adjust the hand-control accelerograph.
When the engine speed is in 800rpm and the vacuum gauge point to 0.04-0.06, the
tank begins to drain. At the same time, loosen the clutch and the vacuum pump
starts exhaust air to drain the excrement inside the tank through the suction
tube. After drained, the engine must stop immediately, turn the PTO off, reel
the suction tube out and place it on the truck.
The drain automatically
process
Open
the drain valve at the top of the tank, the excrement will flow automatically.
After drain, the drain valve must be closed firstly, and then drive the truck
to avoid the remains liquid pollution for the road. (Attention: this operation
will be done just on the occasion of malfunction to the engine or vacuum pump.
Or this operation is not done. )
1.
The lubrication type is BM-14 or machine oil instead.
2.
The lubrication for the vacuum pump must be change in a period. Generally,
after use 120-150 times, the oil should change to new ones.
3. When the vacuum pump works in order, the engine speed is 800-1400rpm. Too high
or below is not up to the work requirement of the vacuum pump.
4.
After gear to the PTO, the clutch pedal should loosen slowly. Because the high
speed running of the vacuum pump will damage to the components inside the
pump.
5.
Before every work days, the tank and all air tubes should be checked, never
leak of air, oil and liquid.
6
.Check tank vacuum pump, shaft and all bolts and nuts of the PTO every day.
7.
Check and maintain the alarm instrument every day to make sure it’s sensitive.
8.
The vacuum pump and all parts should maintain according to the entire truck
technology maintenance and lubricate.
9.
When the vacuum gauge points to 0.07-0.08, but the excrement don’t enter the
tank, it means that the suction tube is jammed. You should stop the engine and
vacuum pump, dredge the tubes and then start inbreathing.
10.
It is suggested have a test with water to acquaint with the operation before
using the truck.
11.
Half-load transportation is forbidden strictly.
12.
The truck must work on level road or ground, don’t be working if the truck is
askew.
The attentions when you use it:
1.
The truck must work on level road or ground, don’t be working if the truck is
askew.
2.
The oil for the vacuum pump should be often changed and added to keep its
volume inside the pump up to 1/2.
3. Keep the vacuum pump speed below 1000rpm, never exceed that speed!
4.
Any sundries mustn’t enter into the pump.
5.
The excrement can not fill with the tank.
Our quality promise
Base
on the custom abiding to the manual, if the running distance is within 25000km,
the maintenance period of the tank is one year. For vacuum pump, all valves and
drive shaft the validity is six months, and the rubber parts will keep repair
within three months. All parts easy to damage such as electric parts, lights
are out of the maintenance range. Our maintenance service reaches you within
24-48 hours.
8.
Technology documents accompanied with the truck
8.1
Product Acceptance Certificate
8.2
Product Manual and quality certificate
Please feel free to contact us：
China
Suizhou Hubei chusheng Special Purpose Vehicle Manufacture Co.,Ltd.
Tel:
0086-722-3820788 Fax: 0086-722-3820688
Service
Tel: 0086-722-3820688
Web:
www.cs-truck.com E-mail:
info@cs-truck.com
没有评论:
发表评论